Rv Furnace Thermocouple Location

If your hands get too cold you might lose the dexterity you need to identify and fix the furnace problem.

Rv furnace thermocouple location.

Amazon favorite rving products page. Especially if you can t get the rv to a safer location. It should be positioned properly in the pilot flame so make any necessary adjustments if it isn t sitting right or replace it at this time if it s broken altogether. The problem could also be that the propane tank has a bad regulator.

Most gas furnaces use either a flame sensor or a thermocouple often referred to as a thermal coupler both are safety devices that sense the presence of a flame and control the flow of gas to the appliance accordingly. Examine the area for rust dirt soot or similar materials and if present around the thermocouple clean them away. It shuts down and won t maintain any heat. If no flame is present the sensor stops or prevents the flow of gas from the gas valve thus preventing the dangerous situation of gas flowing into the appliance when there.

If the pilot light on your rv furnace will not light check that the thermocouple is correctly positioned in the pilot flame. If the pilot flame goes out the thermocouple will automatically shut off the flow of gas through the gas valve thereby removing the fuel source and preventing the accumulation. The exhaust is an air outlet on the exterior of the rv that exhausts the gases produced during the combustion process the gases are a combination of carbon dioxide and carbon. A thermocouple is a safety device that s used to detect whether or not your furnace s pilot light is lit.

The rv furnace will fire up but for some reason won t stay turned on. The thermocouple is an electo mechanical safety device that senses if the pilot flame in an rv appliance is present. Also be sure to check the furnace vent for blockages. Luckily the problem is common enough that every technician or repairman will give the same answer it s the control board.

When your pilot light is lit the heat from the flame sends a voltage through the thermocouple that. The ducts carry the heated air from the furnace to the interior of the rv. It contains a metal rod that is placed very close to your pilot light s flame. This rod is connected to your furnace s gas valve.

You can test for a bad regulator by lighting all the stove burners and examining the color of the flames. The dsi is an acronym direct spart ignition it s an electronic igniter that uses a spark ignites the gas air mix. Locate your refrigerator s thermocouple by removing its service panel which is generally located either behind the front grate within a panel at the back of the fridge or accessible through an exterior service panel on an rv.